ENAMEL BONDING AGENT

E-Bond is a light-cuarable, bonding agent for use on enamel, composite and etched silanated porcelain. Unfilled resin, with ultra-thin film thickness.

Specifications

• 10 ml bottle

Adhesive used by itself, without the self-etching primer, serves as a superior total-etch adhesive when total etch technique is preferred. It compares to Optibond Solo Plus.**

Link converts Prelude to dual-cure when needed for self/dual cure composites. This makes Prelude ideal for posts and other indirect restorations.

Prelude One is a light-curable single component self-etch adhesive designed to bond composite resins to most dental surfaces. These surfaces include dentin, enamel, zirconia, alumina, metals, porcelain, lithium disilicate, and composite restorations. As a universal adhesive, Prelude One is truly compatible with light cured, dual cured, and auto cured composites (no activator required).

FEATURES

• Convenient one step application
• For use on all surfaces
• No post-op sensitivity
• Extremely high bond strengths to all direct and indirect restorations
• Compatible with dual and self cure composites without the use of an additional activator

SPECIFICATIONS

5 ml bottle

The primer is water based with a methacryl phosphate and hydrophilic monomer to condition the tooth prior to restoration.

Independent test results confirm that Prelude has the highest 5 minute and 24 hour bond strengths. Prelude was shown to have the smallest standard deviation, proving its consistent performance. Studies available upon request. 

Long, two year shelf life

Specifications

• 1 Primer 5 ml
• 1 Adhesive 5 ml

Independent tests confirm that Prelude has the very high 5 minute and 24 hour bond strengths. It also has the smallest standard deviation,* proving Prelude to be very technique insensitive.

Prelude is extremely forgiving in the presence of moisture. Too wet, or too dry is not a concern. Its water/ethanol formulation tolerates an environment that would adversely affect other products.

The remarkably low 5 micron film thickness means fit is not affected and it will not present a radiolucent layer. Bond strengths to cut and un-cut enamel are extremely high. It is ideal for Cerec** and other milled systems.